Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

内置转盘式膜-生物反应器处理污水的工艺条件研究

对内置转盘式膜-生物反应器(SRMBR)处理污水工艺进行了研究.进水COD 160～368 mg/L时,出水COD在运行1d后降低到20 mg/L以下,去除率大于90%;转盘式膜组件的转速在0～25 r/min范围内,平衡膜通量随转速增大而快速增加,继续增大转速则平衡膜通量的增加变得不显著;在一定范围(0～1min)内延长停抽时间有助于缓解膜污染;SRMBR在较低的气水比(15∶1)下运行,也可达到较高的平衡膜通量.研究表明,SRMBR在最佳组合操作条件(转速为25r/min,抽/停为9min/1min,气水比为15∶1,抽吸压力为25kPa)下运行,其平衡膜通量高达53.75L/(m²·h).     

聚合氯化铝-腐殖酸(PACl-HA)絮体的物理与分形特征研究

采用低温急速冷冻-真空干燥技术制备了PACl-HA絮体的粉末样品,研究了这些样品的物理与分形特征.结果表明,PACl-HA絮体具有无定形结构,主要组成元素为C、O、Al,所含特征官能团保留了絮体组成原料的一些特征;絮体的BET比表面积为130～161 m²·g^-1,BJH累积吸附孔体积为0.38～0.52 cm³·g^-1,BJH脱附平均孔径为7.7～9.6nm,PSD峰值对应孔径8.4～11.2nm.PACl-HA絮体具有自相似性的粗糙表面,呈现多尺度分形特征;图象法和N₂吸附/脱附等温线法确定的表面分形维数Ds分别为2.03～2.26、2.24～2.37,前者的分形尺度大约处于23～390nm之间,主要属于絮体外表面尺度,而后者的分形特征尺度区间的下限大约为0.2nm,属于孔表面尺度;另外,对同一絮体,N₂吸附法和脱附法确定的孔表面分形维数不同.热力学模型计算出的D_s远大于3,与Sahouli等的研究不符.     

烟气脱硫剂制浆系统一体化设计及应用

石灰石粉制浆系统是石灰石-石膏湿法烟气脱硫工艺中脱硫剂浆液干式制备系统的一个主要部分。针对石灰石粉制浆系统传统设计的不足,提出了石灰石浆液罐与粉仓一体化设计的优化方案,具有节省投资、占地小、设计简单紧凑、系统可靠和寿命长的优点,尤其适合我国老小燃煤机组烟气脱硫改造工程。目前已成功应用于多个烟气脱硫工程。     

超声破解污泥上清液对A~2O工艺脱氮除磷和微生物群落结构的影响

为了提高传统污水处理工艺的脱氮除磷效率、实现污泥资源化,本实验通过超声破解污泥获取碳源,采用耗氧呼吸速率分析上清液作为碳源的可行性,并将上清液回用于生活污水,考察其对A2O工艺长期运行的脱氮除磷效果和微生物群落结构的影响。结果表明,上清液中可降解有机物达到76.2%,具有作为内碳源的潜能;上清液和生活污水按1∶15投入A2O反应器后,氮、磷的去除率分别从63.2%和53.4%提高到了82.1%和94.7%;上清液明显改变了微生物群落结构,使除磷菌Actinobacteia和反硝化聚磷菌Sphingobacterium富集。     

Biodegradation of methyl red by Bacillus sp. strain UN2: decolorization capacity,metabolites characterization,and enzyme analysis

Azo dyes are recalcitrant and refractory pollutants that constitute a significant menace to the environment. The present study is focused on exploring the capability of Bacillus sp. strain UN2 for application in methyl red (MR) degradation. Effects of physicochemical parameters (pH of medium, temperature, initial concentration of dye, and composition of the medium) were studied in detail. The suitable pH and temperature range for MR degradation by strain UN2 were respectively 7.0–9.0 and 30–40 °C, and the optimal pH value and temperature were respectively 8.0 and 35 °C. Mg²⁺ and Mn²⁺ (1 mM) were found to significantly accelerate the MR removal rate, while the enhancement by either Fe³⁺ or Fe²⁺ was slight. Under the optimal degradation conditions, strain UN2 exhibited greater than 98 % degradation of the toxic azo dye MR (100 ppm) within 30 min. Analysis of samples from decolorized culture flasks confirmed biodegradation of MR into two prime metabolites: N,N′dimethyl-p-phenyle-nediamine and 2-aminobenzoic acid. A study of the enzymes responsible for the biodegradation of MR, in the control and cells obtained during (10 min) and after (30 min) degradation, showed a significant increase in the activities of azoreductase, laccase, and NADH-DCIP reductase. Furthermore, a phytotoxicity analysis demonstrated that the germination inhibition was almost eliminated for both the plants Triticum aestivum and Sorghum bicolor by MR metabolites at 100 mg/L concentration, yet the germination inhibition of parent dye was significant. Consequently, the high efficiency of MR degradation enables this strain to be a potential candidate for bioremediation of wastewater containing MR.     

Fenton氧化与铁炭微电解组合预处理DMF废水

对COD表征模拟废水中DMF去除率的可行性进行了探讨。在此基础上,分别对铁炭微电解、Fenton氧化-铁炭微电解和铁炭微电解-Fenton氧化组合工艺对DMF废水的处理效果进行分析,结果表明,Fenton氧化-铁炭微电解工艺的处理效果较好。在pH=5,反应时间为1 h,FeSO4·7H2O投加量为1 000 mg/L、H2O2投加量为2.67 mL/L和不曝气的最佳反应条件下,Fenton氧化-铁炭微电解工艺对实际废水和废液中COD的去除率分别达到66.67%和72.22%,从而验证了该工艺处理DMF废水的可行性。此外,Fenton氧化处理DMF废水过程实际上是将酰胺基团和羰基的不饱和双键氧化分解的过程。     

Leaching behaviour of different scrap materials at recovery and recycling companies: Full-, pilot- and lab-scale investigation

Scrap material recovery and recycling companies are confronted with waste water that has a highly fluctuating flow rate and composition. Common pollutants, such as COD, nutrients and suspended solids, potentially toxic metals, polyaromatic hydrocarbons and poly chlorinated biphenyls can exceed the discharge limits. An analysis of the leaching behaviour of different scrap materials and scrap yard sweepings was performed at full-scale, pilot-scale and lab-scale in order to find possible preventive solutions for this waste water problem. The results of these leaching tests (with concentrations that frequently exceeded the Flemish discharge limits) showed the importance of regular sweeping campaigns at the company, leak proof or covered storage of specific scrap materials and oil/water separation on particular leachates. The particulate versus dissolved fraction was also studied for the pollutants. For example, up to 98% of the polyaromatic hydrocarbons, poly chlorinated biphenyls and some metals were in the particulate form. This confirms the (potential) applicability of sedimentation and filtration techniques for the treatment of the majority of the leachates, and as such the rainwater run-off as a whole.